#E.t furby instruction manual install#
#E.t furby instruction manual serial#

Run GOSTAI Console (or other telnet type), set connection port settings and connect to the already running engine. By default, basic set of Open FURBY competencies is loaded, which can be called via Urbi console. To start Open FURBY, run single.exe or single.bat ( edit it if needed) from modules catalog this will launch Urbi engine and load Open FURBY configuration file along with all the necessary functions.ДЄfter loading all files, you should see 'ROBOT READY :-)' info. You should change _com_furby variable (from вЂњCOM3вЂќ to appropriate COM number) in FURBY CONFIGURATION section.

#E.t furby instruction manual serial#

For more information see Control system configuration in Software section.Д¬heck the number of Open FURBY Serial Port in Device Manager and modify _CONFIG_.u file in urbiscripts folder. The main configuration file is called _CONFIG_.u and is located in ubi_scripts catalog.

From GitHub LINK, download modules LINK and urbi_scripts LINK folders and copy them to your main URBI folder.Д«efore starting Open FURBY, you should configure his control system.

#E.t furby instruction manual install#

For working with Urbi install Urbi console LINK and Urbi editor LINK.Download Urbi Engine 2.7.5 SDK LINK and extract all files to this folder.Create main URBI directory on your hard drive (or cloud drive) (see fig.Driver are usually installed automatically by Windows if not install the following driver LINK. In the end, we have to stick copper tape as a touch sensor to: head, back, both sides and belly.ДЄfter connecting Open FURBY USB connector to the master PC controller you must install serial control port driver. When the wire is out of furby we fasten original furby speaker. We use the original furby encoder and вЂzero positionвЂ™ sensor. We solder all wires (to displays and to the switch) and bring them out of furby casing. Next step is to fasten the switch, which is use to check if the tongue is pushed. SD card slots should be also removed to get more space inside. We do not need voltage translators and voltage regulators because we use 3V3 in the whole system. We also grind PCB of OLED displays.ДЄdafruit displays' electronic should be also modified. Next we grind the frame, which is around the LCD eyes. The holes were needed in the first version of mounting OLED displays, but we changed it, so you do not have to cut your furby so much. We have to cut out the both side of furby. It is necessary because we need some space for new OLED displays as eyes. First we start to modify plastic casing of furby.